What does BC’s zero carbon step code say about heating?

Quick answer

For a new home near Vancouver, the Province of BC’s zero carbon step code sets emission targets and speaks of space heating, but its page does not name heat pumps. The builder or the city can say which step a home meets. A planned heat pump has a separate program, the National Heat Pump Rebate, with its own official page.

In this guide

  • What is the zero carbon step code?
  • What are the four steps, and which one is the baseline?
  • Can a city ask for more than the baseline?
  • What does the page say about heating, and does it name heat pumps?
  • What should you ask before choosing heating for a new build?
  • Common mistakes to avoid
  • How to choose and what to do next

Three questions sort this topic. Which step is the home designed to meet? Has the city added expectations beyond the provincial baseline? What heating equipment do the plans name? This post reads the Province’s page as of November 2026, and a code like this can be revised, so the sections below end with questions for your builder.

What is the zero carbon step code?

According to the Province of BC, the Zero Carbon Step Code complements the BC Energy Step Code, and its stated purpose is emission reduction targets for new buildings. The page says the code was introduced in May 2023.

It is a framework for builders and local governments rather than a product list, so it does not pick a brand or a type of equipment. Because rules like these can be revised, anyone relying on them for a project should check the current version of the page and confirm it with their city or builder.

What are the four steps, and which one is the baseline?

The page lists four steps: EL-1, which it labels a measuring step, then Moderate Carbon Performance (EL-2), Strong Carbon Performance (EL-3) and Zero Carbon Performance (EL-4). The page also states that starting March 10, 2025, the Province will require most new buildings to meet or exceed EL-1.

That sentence describes a baseline for most new buildings, not all of them, and it does not set a heating technology. Which step applies to a given address is a question for the builder or the permitting office, since the page does not say.

Can a city ask for more than the baseline?

The page says local governments and other authorities with jurisdiction can incentivize or require builders to meet any step of the code. A municipality might therefore encourage or require a higher step than the provincial baseline, and requirements can differ from one city to the next.

That is why a general web page cannot settle the question for a particular lot. A buyer of a new build in Vancouver, for example, would put the question to the city that issues the permit, and keep the written answer with the purchase documents.

What does the page say about heating, and does it name heat pumps?

The page describes a prescriptive path that requires builders to decarbonize energy-intensive appliances. It names space heating, water heating and cooking equipment as examples. It also says most builders will need to decarbonize domestic heat, hot water, or both, depending on local requirements.

The page does not mention heat pumps by name, so it does not say which equipment a builder must select. A reader should not take it as a statement that heat pumps are required, or that they are ruled out. It describes a goal for these appliances rather than listing approved models, so the builder’s plans show what the home will actually use.

A heat pump installation involves other rules as well. Technical Safety BC says that for most residential installations or upgrades, an electrical permit and an electrical contractor to perform the work are needed. The page adds that a homeowner can apply for permits, but a hired contractor applies on the homeowner’s behalf.

What should you ask before choosing heating for a new build?

A short list helps when you compare builders or heating options, and the answers are easier to compare when they are written down. A natural resources department page also recommends that a heating and cooling professional do the sizing calculations.

  • Ask the builder which step the home is designed to meet
  • Ask the city whether it has added expectations of its own
  • Ask what heating equipment is planned and why
  • Ask who applies for the electrical permit
  • Ask how the system will be sized for the home

Common mistakes to avoid

  • Reading the page as a statement that heat pumps are required, or as one that rules them out; it names neither.
  • Assuming the baseline is the same in every city, when local governments can incentivize or require any step.
  • Treating a summary, including this one, as the rule; the Province’s page can be revised.
  • Accepting a verbal answer about the step the home meets instead of asking the builder for it in writing.
  • Overlooking the permit for heat pump work: Technical Safety BC says most residential installations or upgrades need an electrical permit and an electrical contractor.

How to choose and what to do next

The default recommendation is to ask the builder, in writing, which step the home is designed to meet and what heating equipment is planned. One rule applies throughout: the builder’s plans and the city’s requirements decide the answer, and a web page does not. Look again before you sign, or whenever the plans change. Ask Alfa Services whether it can answer questions about your own home.

Frequently asked questions

Does BC’s zero carbon step code require a heat pump?

The Province of BC page does not name heat pumps. It describes emission reduction targets for new buildings and mentions decarbonizing space heating, water heating and cooking equipment in general terms.

Who decides which step applies?

The page says the Province requires most new buildings to meet or exceed EL-1 from March 10, 2025, and that local governments can incentivize or require any step. The builder or the city can say which applies to a given home.

When was the code introduced?

The page says the Zero Carbon Step Code was introduced in May 2023.

Does a heat pump need a permit?

Technical Safety BC says most residential installations or upgrades need an electrical permit and an electrical contractor to do the work. A hired contractor applies for the permit on the homeowner’s behalf.

Read more about heat pump from Alfa Services.

Questions about heat pump? Call 778-899-9989 or visit alfaservices.ca.

This post is general information, not financial, legal or technical advice. Rebate amounts, dates and rules change, and programs may run out of funding. Check the official program page and ask a licensed contractor before you buy or sign. For your own situation, contact Alfa Services directly.

This article was written with AI. The video is presented by an AI avatar.